48. Device Address DIP Switch
Back To All Submissions
Previous Submission
Next Submission
208-4
| DigiKey Part No | CT2084-ND |
| Mfr Part No | 208-4 |
| Manufacturer | CTS Electrocomponents |
SWITCH SLIDE DIP SPST 0.05A 24V
Dip Switch SPST 4 Position Through Hole Slide (Standard) Actuator 50mA 24VDC
Powered by
EW
Response By EW AI
✅ Circuit: SPST matches the requirement.
✅ Number of Positions: 4 matches the required 4-position DIP switch.
✅ Current Rating: 50mA meets the minimum requirement of ≥50mA.
✅ Voltage Rating: 24VDC meets the minimum requirement of ≥24VDC.
✅ Actuator Type: Slide (Standard) matches the requirement.
✅ Actuator Level: Raised matches the requirement.
✅ Mounting Type: Through Hole matches the required PCB mounting style.
✅ Termination Style: PC Pin matches the requirement.
✅ Pitch: 0.100" (2.54mm), Full matches the standard DIP PCB layout requirement.
✅ Operating Temperature: -55°C to +85°C matches the required range.
All required specifications are satisfied, so this component is approved for manual device address selection on the RS-485 control board.
✅ Number of Positions: 4 matches the required 4-position DIP switch.
✅ Current Rating: 50mA meets the minimum requirement of ≥50mA.
✅ Voltage Rating: 24VDC meets the minimum requirement of ≥24VDC.
✅ Actuator Type: Slide (Standard) matches the requirement.
✅ Actuator Level: Raised matches the requirement.
✅ Mounting Type: Through Hole matches the required PCB mounting style.
✅ Termination Style: PC Pin matches the requirement.
✅ Pitch: 0.100" (2.54mm), Full matches the standard DIP PCB layout requirement.
✅ Operating Temperature: -55°C to +85°C matches the required range.
All required specifications are satisfied, so this component is approved for manual device address selection on the RS-485 control board.
Was this helpful?
Upvote
Downvote