63. Optocoupler Part Selection

Question.6

Hardware Developer is selecting an optocoupler to isolate a CAN bus receive line running at 500 kbps between a battery-powered sensor module and an automotive ECU. The design requires:

Single-channel optocoupler, isolation ≥ 2.5 kVrms, propagation delay ≤ 100 ns, data rate ≥ 1 Mbps, logic-level output, DIP package

She chooses the DigiKey part number: 160-1366-5-ND (Lite-On LTV-817)

Is this the correct component for the given requirement?

Need Help? Refer to the Quick Guide below

Select Answer

Yes, it matches all requirements
No, the speed / propagation delay is too slow
No, the isolation voltage is too low
No, the package is incorrect